> We will set the horizontal and vertical numbers of magnification to 200 eachĪt this point, the message "There is no transformation target" is displayed, and the tool property can not be selected. > Select "Enlarge, Reduce, Rotate" from "Edit" from the Edit menu When you make a selection on the canvas, you can create a range with a small round circle on the drawing. This last "create a selection on the canvas"īut it does not work well. > Set the horizontal and vertical to 90 (mm) respectively > Check "Designation of vertical and horizontal direction" of tool property > Select Elliptical Selection of Sub Tool can be used togetherĮven if you lose the selection, you can restore the selection by selecting Reselect in the Selection menu. I think that "fit canvas size to the selection range" of the edit menu etc. I think that "layer mask out" from "layer mask" in "Layer" menu is also good.
I think that you may cut it freely after thisĬlear out of selection range of edit menu
Select Quick Mask again from the selection menu to return to the selection Move the quick mask so that the illustration fits in it We will set the horizontal and vertical numbers of the magnification to 200 each Set the horizontal and vertical to 90 (mm) respectivelyĬhoose a quick mask from the selection menuįrom the Edit menu, select "Translate," "Zoom, Zoom, Rotate". You need to enlarge the picture if you adjust the size to a circle of 18 cmĬheck "Designation of vertical and horizontal direction" of tool property If drawn more than 18 cm you need to shrink
0 kommentar(er)
